StarkNet Helper
  • Introduction
  • Usage
    • General
    • Modules
      • Swap
      • Liquidity
        • Add liquidity
        • Remove liquidity
      • Deploy
      • Upgrade
      • Transfer
      • Lending
        • Supply
        • Withdraw
      • Stark ID
      • Bridge
      • Trash txn's
      • Zerius
      • Dmail
    • Wallets
    • Run settings
    • Actions (Tasks)
  • Installation
    • Requirements
    • Launch
  • Other
    • Settings
    • Tools
    • Coin contracts
  • Contacts
  • Support
Powered by GitBook
On this page
  1. Usage
  2. Modules

Transfer

Tokens transfer module

PreviousUpgradeNextLending

Last updated 1 year ago

You can use this module to transfer any added coin to another Stark address. The recipient's address should be specified in the wallet settings as a pair address (more information about setting up wallets).

  • Min amount & Max amount - the final amount of coin to transfer will be randomly chosen in the range of these numbers. If the maximum amount to transfer exceeds the current wallet balance, the wallet balance will be used as the maximum value.

  • Use all balance - will transfer all the coins you have in your wallet.

  • Send % of balance - It will randomly select a number from the minimum and maximum amount fields. This number will represent the percentage of tokens used from your wallet balance.

  • Max fee - maximum fee (GWEI) that could be charged for transaction execution (you can read more about gas in ). If the "Forced max fee" parameter is not enabled, the maximum fee will be replaced with the estimated transaction overall fee.

  • Forced max fee - when turned on, the maximum gas limit will be exactly taken from the input.

stark guide